ExamTorrent 301a Exam Questions | Real 301a Practice Dumps
Verified 301a Exam Dumps Q&As - Provide 301a with Correct Answers
F5 301a exam covers a wide range of topics, including BIG-IP LTM architecture, installation and setup, traffic processing, high availability, security, and more. Candidates are required to have a deep understanding of the underlying technologies and protocols used in F5 BIG-IP LTM systems, such as HTTP, SSL, TCP, and IP. They must also be able to design and implement complex BIG-IP LTM solutions that meet the specific needs of their organization.
To pass the F5 301a Exam, candidates must demonstrate their ability to design, configure, and deploy the F5 BIG-IP LTM solution in a variety of scenarios. 301a exam is designed to test the skills and knowledge required to deploy and manage the F5 BIG-IP LTM solution, including its advanced features and capabilities. Candidates will need to demonstrate their ability to configure and manage virtual servers, load balancing, and traffic management policies, as well as their understanding of security and authentication features.
NEW QUESTION # 72
An LTM Specialist needs to configure a setup for antivirus scanning of HTTP traffic with an internet Contact adaption Protocol (ICAP) server.
Which two server type should be used? (Choose two.)
- A. Forwarding IP
- B. Stateless
- C. Internal
- D. Performance HTTP
- E. Standard
Answer: C,E
NEW QUESTION # 73
An LTM Specialist is configuring a new virtual server on an LTM device and assigning a SNAT pool that is already is use another virtual server. Both virtual servers use the same pool members to load balance traffic. A maximum of 35,000 users needs to be able to access each virtual server ta any time. The network architecture does NOT allow the backend servers to use the LTM device as a default gateway.
What is the minimum number of SNAT addresses required in the SNAT pool to meet the needs of the virtual servers?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
Explanation:
Both vs share the same snat pool, and both use the same pool member. Then the concurrent number of snatpool will be added. For each VS, there is a maximum of 35,000 users, and those two VSs have a maximum of 70,000 users. The stem did not mention how many connections each user would have concurrently. Calculated with a minimum of 1 connection, then 70,000 connections would be concurrent. One IP can support 65,535 connection. Therefore, at least 2 or more snaptips are required
NEW QUESTION # 74
An LTM Specialist configures a new HTTPS virtual server that contains a valid example.com ssl certificate. The LTM Special receives an error in the browser when connecting.
What must be added to the SSL Client profile to fix this issue?
- A. An intermediate certificate
- B. A new example com certificate
- C. A sell-sign certificate
- D. A public root certificate
Answer: A
NEW QUESTION # 75
A company plans to launch a huge marketing campaign and expects increase demand of their secure website. With the current virtual server setup, the LTM Specialist expects that the LTM device will reach its capacity limits. For the wen application to function properly. Cookies persistence is required. The LTM Specialist needs to reduce LTM device load without breaking the application.
Which two settings should the LTM Specialist modify to meet the requirement? (Choose two.)
- A. Remove HTTP profile
- B. Remove HTTP compression profile
- C. Remove web acceleration profile.
- D. Remove ClientSSL profile
- E. Modify virtual Server type to performance (Layer 4)
Answer: B,C
Explanation:
It is required that cookie persist must be used and http profile must be used, and SSL offloading must also be required. It must be in standard mode, excluding BD E.
NEW QUESTION # 76
An application requires load balancing functionality. The application must be encrypted to the client.
Certain content must be manipulated by the following IRule:
Which set of profiles must be applied to the virtual server?
- A. TCP, HTTP server SSL Stream
- B. TCP, HTTP, Client SSL, Stream
- C. TCP, HTTP, OnceConnect, Stream
- D. Fast L4, HTTP server SSL Stream
Answer: B
Explanation:
Client encryption is required , clientssl, irule contains HTTP events and stream execution, http profile stream profile.
NEW QUESTION # 77
An LTM Specialist needs to provide statistics regarding the round-trip time between the clients and the servers.
Which metric should be part of the analytics profile to provide that information?
- A. Response Codes
- B. Max TPS and Throughout
- C. Page Load Time
- D. User Sessions
Answer: C
NEW QUESTION # 78
Refer to the exhibit.
An LTM Specialist has multiple SNAT and virtual server objects configured as in the bigip.conf shown.
The LTM Specialist tests a connection from a client with. IP 172.163.31.11 to 192.168.0.100:80.
Which two objects will show an increase in Local Traffic statistics connections?
- A. VS_A & SNAT A
- B. VS_ B & SNAT A
- C. VS_A&SNAT_B
- D. VS_B&SNAT_B
Answer: C
NEW QUESTION # 79
A web server's default gateway is the network router. The LTM Specialist needs to introduce an LTM device to load balance to the web servers without changing the server's default gateway.
Which deployment method and settings should the LTM Specialist use to ensure correct traffic flow and that the web servers can obtain the actual con IP addresses?
- A. route deployment without SNAT configuration
- B. route deployment with Automap configured and X-Forwarded-For inserted in HTTP headers
- C. SNAT deployment with automap configured and X-Forwarded-For inserted in HTTP headers
- D. SNAT deployment with automap configured
Answer: C
NEW QUESTION # 80
An LTM device configured with a management IP address and route and a series of self-IPs and TMM routes. Both management and TMM have a routing entry for 101 10/24 Application traffic is being load balanced and sent to pool member 10.1.1.123 with SNAT Automap and configured.
Which route will the LTM device use?
- A. TMM route regardless of the management port status
- B. management route when TMM interface is down or TMM is offline
- C. both routes, which will duplicate traffic on both management and TMM interface
- D. equal cost multipath load balancing via both routes
- E. management route regardless of the management port status
Answer: A
NEW QUESTION # 81
A virtual server configuration for traffic destined to a server is as shown:
HTTP traffic is destined to the 10 10.20.1 server from the source
Based on precedence, which virtual server accepts this traffic?
- A. MyVS2
- B. MyVS4
- C. MyVS3
- D. MyvS1
Answer: A
NEW QUESTION # 82
Refer to the Exhibit.
An LTM Specialist notices that two members in a pool are overloaded. To relive the existing members a fourth member (10.128.20.14) is brought up.
How many member will receive and process new connections?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 83
An LTM device load balances a pool of routers. The LTM device needs to verify path availability to an HTTP server with the IP address 192 168.10 10. located beyond the routers.
Which monitor type and parameters arc required?
- A. HTTP monitor alias address 192 168.10 10. and set the alias to port 80
- B. TCP monitor, change transparent option to Yes, and sot the alias to port 80
- C. TCP monitor, alias address 192.168.10.10. and set the alias to port 80
- D. TCP monitor change transparent option to Yes. set alias address 192.168.10.10. and set the alias to port 80
Answer: D
NEW QUESTION # 84
A web developer needs a virtual server configured for an application.
The application details are as follows:
Application is accessed on port 443.
The application traffic is encrypted by the server.
HTTP is not being used. No data manipulation is necessary.
Throughput is critical.
NO connections are terminated on the LTM.
Which configuration provides the best performance?
A)
B)
C)
D)
- A. Option
- B. Option
- C. Option
- D. Option
Answer: D
NEW QUESTION # 85
An LTM is configure an application that is separated into several subdomains across multiple virtual servers. Many of these subdomains require encryption and could be accessed by anyone on the internet. The configuration must NOT result in SSL warnings to end users.
How should the LTM Specialist configure the SSL profiles for these virtual servers?
- A. Create a self-singed SSL certificate for each subdomain make a ClientSSL profile for each subdomain, and apply to the related SSL Virtual server
- B. Create a self-singed SSL certificate for each subdomain make a Client profile for each SSL Virtual Server
- C. Obtain a wildcard certificate, create one ClientSSL profile and apply to all SSL Virtual Servers
- D. Obtain an SSL certificate for each subdomain, make a ServerSSL profile for each subdomain, and apply to the related SSL Virtual Server.
Answer: C
Explanation:
The topic is that there are multiple domain names in the business, and HTTPS services are provided to the internet, and users cannot be allowed to generate SSL alarms. The require client ssl and use CA certificate instead of self-singed certificate. And multiple domain names, you can use wildcard certificates.
NEW QUESTION # 86
An LTM Specialist is experiencing issues in a failover event. Certain long-lasting FTP event. Certain long-lasting FTP connections using a single node pool are forced to reconnect. The bigip.conf extract is shown:
What does the LTM Specialist need to change in the configuration to avoid this issue?
- A. ftp profile
- B. connection mirroring
- C. persistence mirroring
- D. snatpool
Answer: B
Explanation:
The stem mentions that it is a single server node, so there is no need to consider the factors of session maintenance. The actual requirement is to maintain the original connection status during failover. You need to configure connection mirroring to synchronize the connection status between the devices in the cluster in real time.
NEW QUESTION # 87
A pool has four members. Ail of the servers have been designed and configured with the same application. Each client's request can significantly the performance of the servers.
Which load balancing method should the LTM Specialist use to maintain a relatively even load across all servers?
- A. Ratio
- B. Least Connections
- C. Observed
- D. Priority Group
Answer: B
NEW QUESTION # 88
An LTM Specialist reports that an application si no longer reachable after it has been upgraded.
Nothing has been changed in the configuration on the LTM device.
The logs indicates that health monitors to all servers have failed as shown:
What should the LTM Specialist verify next?
- A. That the custom receive string for the HTTP monitor has changed with the upgrade
- B. That the firewall between the BIG-ip device and servers is still allowing HTTP
- C. That the can still ping the servers from te BIG_ IP device.
- D. That the TCP hand shake with the servers is stall completed using tcpdump
Answer: A
Explanation:
The log shows that tcp detection is normal, but http detection is abnormal. So we should pay attention to the detection problem of http level
NEW QUESTION # 89
......
Get Top-Rated F5 301a Exam Dumps Now: https://vcetorrent.examtorrent.com/301a-prep4sure-dumps.html
